INSTALLATION VIDEOS

The installation video Chapters correspond to the Steps in the printed installation manuals.

VIDEO CHAPTERS

Identify the Header Bars (Header Bars for Club Car DS Pre-2000 and Precedent are different than what is in the video. Refer to your written manual.

Tap End Caps into ends of Header Bars (Applies to cart models with 3/4" square tube Headers only.)

Add T Bolts to Channel in cart roof

Install the Header Bars - Position the front of the Header Bar according to each cart model. Refer to your printed manual for details. The position of the Header Bar is critical to a successful installation of your Enclosure. UPDATE: All kits now contain HEX HEAD bolts to attach the Headers instead of Phillips Head screws as seen in the video.

Install the 1 1/2" Hex Head screws that are used to attach the Door Posts to the Headers.

REAR DOOR POST INSTALLATIONS VARY FROM CART MODEL TO CART MODEL.
FIND YOUR MODEL BELOW.

REAR DOOR POSTS FOR EZGO SPORT 2+2 and TXT
Attach J Bolts to the bottom of the Rear Door Post

Install the Rear Door Posts and place the Square Tubing Spacer between the rocker panel and the metal frame behind the bottom of the Rear Door Post.

Install the bottom of the Rear Door Post (This is the same procedure for the Front Door Posts also.)

REAR DOOR POSTS FOR CLUB CAR DS CARTS (This video shows a 2 passenger cart, but the process is the same for a 4 Passenger cart.)
Attach Door Post “L” Brackets or “J” Hooks to all four door posts.

Install the Rear Door Post

REAR DOOR POSTS FOR CLUB CAR PRECEDENT CARTS
Rear Door Post for Precedent
Install the Rear Door Post Bottom L bracket. This bracket connects underneath the golf cart to two bolts. Then, the Rear Door Post is connected to the "window slot" on the L bracket. The video shows the Passenger Side of the golf cart.

FRONT DOOR POST INSTALLATIONS VARY FROM CART MODEL TO CART MODEL.
FIND YOUR MODEL BELOW.

FRONT DOOR POSTS FOR CLUB CAR DS CARTS
Install the Front Door Post.

FRONT DOOR POSTS FOR CLUB CAR PRECEDENT
Install the Front Door Posts

ALL MODELS - Add Door Frame and adjust for Proper Alignment. The Door Frame should run parallel with the Header Bar and should easily pass under the cart roof.

FABRIC INSTALLATION - THIS SECTION IS BASICALLY THE SAME FOR ALL CART MODELS. THERE MAY BE SOME SLIGHT DIFFERENCES BETWEEN MODELS. REFER TO YOUR WRITTEN MANUAL FOR EXACT DETAILS.

ADD FRONT SIDE PANELS

ADD REAR SIDE PANELS and Rear Valance

ADD BACK PANELS to Rear Valance and Rear Side Panel

ATTACH VELCRO around wheel wells

INSTALL FRONT VALANCE - Attach to Windshield (if applicable to your cart model)

ATTACH STAND OUT STRAPS - These are needed to secure the Doors in the open position when it is more convenient to hold them open - rather than remove them completely.

Reattach the Front Windshield after the enclosure has been installed. Special video regarding some windshields that will need special treatment in order to close through the fabric.